Example Configurations; Pass Through Configuration; Local Domain Configuration - Lenovo Flex System Fabric CN4093 Application Manual

Example Configurations

Pass Through Configuration

1. Create SPAR 1.
2. Add a single uplink port to SPAR 1.
3. Set the mode of the SPAR to passthrough
4. Configure SPAR VLAN to 4081.
5. Add ports INTA5 through INTA10 to SPAR 1.
6. Enable SPAR 1.

Local Domain Configuration

1. Create SPAR 2.
2. Add uplink port EXT 2 to SPAR 2.
© Copyright Lenovo 2015
The following are examples of SPAR pass through and local domain
configurations.
This example describes configuration of SPAR 1 in pass‐through mode with
internal server ports INTA5 through INTA10, with a single port, EXT1.
CN4093(config)# spar 1
Each SPAR is identified with a number that ranges 1 though 8.
CN4093(config­spar)# uplink port EXT1
CN4093(config­spar)# domain mode passthrough
CN4093(config­spar)# domain default vlan 4081
CN4093(config­spar)# domain default member INTA5­INTA10
CN4093(config­spar)# enable
This example demonstrates how to create a SPAR in local‐domain mode consisting
of internal server ports INTA11‐INTA14 and a single uplink port, EXT 2.
CN4093(config)# spar 2
CN4093(config­spar)# uplink port EXT2
Chapter 23: Switch Partition
347