Ip Routing; Setup Part 5: Final Steps - Lenovo Flex System Fabric CN4093 Application Manual

IP Routing

Setup Part 5: Final Steps

1. When prompted, decide whether to restart Setup or continue:
2. When prompted, decide whether you wish to review the configuration changes:
3. Next, decide whether to apply the changes at the prompt:
4. At the prompt, decide whether to make the changes permanent:
5. If you do not apply or save the changes, the system prompts whether to abort them:
54
CN4093 Application Guide for N/OS 8.2
When IP interfaces are configured for the various IP subnets attached to your
switch, IP routing between them can be performed entirely within the switch. This
eliminates the need to send inter‐subnet communication to an external router
device. Routing on more complex networks, where subnets may not have a direct
presence on the CN4093, can be accomplished through configuring static routes or
by letting the switch learn routes dynamically.
This part of the Setup program prompts you to configure the various routing
parameters.
At the prompt, enable or disable forwarding for IP Routing:
Enable IP forwarding? [y/n]
Enter y to enable IP forwarding. To disable IP forwarding, enter n. To keep the
current setting, press <Enter>.
Would you like to run from top again? [y/n]
Enter y to restart the Setup utility from the beginning, or n to continue.
Review the changes made? [y/n]
Enter y to review the changes made during this session of the Setup utility. Enter n
to continue without reviewing the changes. We recommend that you review the
changes.
Apply the changes? [y/n]
Enter y to apply the changes, or n to continue without applying. Changes are
normally applied.
Save changes to flash? [y/n]
Enter y to save the changes to flash. Enter n to continue without saving the
changes. Changes are normally saved at this point.
Abort all changes? [y/n]