Optional Setup for Telnet Support
1. Telnet is enabled by default. To change the setting, use the following command:
© Copyright Lenovo 2015
Enter y to discard the changes. Enter n to return to the "Apply the changes?"
prompt.
Note: After initial configuration is complete, it is recommended that you change the
default passwords as shown in
Note: This step is optional. Perform this procedure only if you are planning on
connecting to the CN4093 through a remote Telnet connection.
CN4093(config)# no access telnet
"Changing the Switch Passwords" on page
65.
55
Chapter 2: Initial Setup