Removing And Installing Dash Panel Central Tube - Volkswagen Jetta 2011 Service Manual

9 - Bolt
❑ Bolt of dash panel central tube to middle tunnel
❑ Qty. 2
❑ Specified torque 20 Nm.
10 - Threaded plate
❑ Threaded plate for middle tunnel bolts
11 - Bolt
❑ Bolt of dash panel central tube to middle tunnel
❑ Qty. 2
❑ Specified torque 20 Nm.
12 - Nut
❑ Nuts of dash panel central tube to bracket
❑ Qty. 2
❑ Specified torque 20 Nm.
13 - Bracket with eccentric
❑ Bracket of dash panel central tube, driver side, bolted to A-pillar
❑ Dash panel can be aligned by means of bracket
❑ Removing and installing
14 - Driver side deformation element
❑ Only USA
❑ Secured to dash panel central tube.
❑ Removing and installing
15 - Middle deformation element
❑ Only USA
❑ Bolted to dash panel
❑ Removing and installing
16 - Bolt
❑ Bolt for bracket ⇒ Item 13 (page 185)
❑ Qty. 3.
❑ Specified torque 20 Nm.
17 - Dash panel central tube
❑ Removing and installing
18 - Bolt
❑ Bolt for bracket ⇒ Item 7 (page 184)
❑ Qty. 2
❑ Specified torque 20 Nm.
3.2 Removing and installing dash panel
central tube
Note
If electrical wires are disconnected or removed and installed, it is
useful to make corresponding drawings or photos. This guaran‐
tees that everything is re-installed in its original position.
General body repairs, interior - Edition 06.2012
⇒ Item 13 (page 185)
⇒ page 189 .
⇒ page 180 .
⇒ page 180 .
to left A-pillar
⇒ page 185 .
to right A-pillar
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
⇒ page 181
3. Dash panel central tube
185