Volkswagen Jetta 2011 Service Manual page 110

Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
General body repairs, interior - Edition 06.2012
– Release connector locking mechanism and pull off connector
-1- from front airbag crash sensor on driver side -G283- -3-.
– Unscrew bolt -2- (4.5 Nm) and remove front airbag crash sen‐
sor on driver side -G283- -3-.
Installing
WARNING
♦ Follow safety regulations for pyrotechnic components
⇒ page 1 .
♦ Before handling pyrotechnic components (e.g. connecting
the electrical connector), the person handling them must
ensure that he/she is "electrically discharged". To do this
e.g. briefly touch the door striker plate.
– Insert front airbag crash sensor on driver side -G283- -3- in
such a way that lug -arrow A- engages in hole -arrow B-.
Note
This is the only way to ensure that the front airbag crash sensor
on driver side -G283- is installed in the correct position.
– Insert and tighten bolt -2- (4.5 Nm).
– Fit connector -1- and engage connector locking mechanism.
Note
Ensure electrical connector is pushed fully onto stop and en‐
♦
gages audibly.
Ensure that no cables are trapped.
♦
WARNING
Battery must be connected with ignition switched on. If pyro‐
technic components (e.g. airbag, seat belt tensioners) are
repaired incorrectly, undesired triggering may occur after the
battery is connected. Ensure that nobody is in vehicle when
connecting battery.
– Connect battery earth cable with ignition switched on ⇒ Elec‐
trical system; Rep. gr. 27 ; Battery; Connecting and discon‐
necting battery .
Note
If airbag warning lamp -K75- indicates a fault following installation,
event memory must be read, deleted and read again ⇒ Vehicle
diagnostic tester.
104
Rep. gr.69 - Passenger protection