Safety Measures When Working On Vehicles With A Start-Stop System - Volkswagen Jetta 2011 Service Manual

Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
General body repairs, interior - Edition 06.2012
⇒ "1.1 Safety measures when working on vehicles with a start-
stop system", page 2
⇒ "1.2 Safety measures when working with pyrotechnic compo-
nents", page 3
⇒ "1.3 Storage, transportation and disposal of airbag, belt ten-
sioner and battery isolator units (pyrotechnic components)", page
4
⇒ "1.4 Additional safety regulations for side airbag", page 5
⇒ "1.5 Additional safety instructions for curtain airbag",
page 5
⇒ "1.6 Safety regulations for crash sensors (pressure sensors) for
front side airbags", page 6
⇒ "1.7 Additional safety instructions for repair work on seat occu-
pied recognition for front passenger airbag deactivation - country-
specific", page 6
⇒ "1.8 Measures for seat occupied recognition for front passenger
airbag deactivation following an accident - country-specific", page
7
⇒ "1.9 Renewing pyrotechnic, electrical and mechanical compo-
nents of the restraint system after an accident", page 7
⇒ "1.10 Checking airbag securing parts after an accident",
page 9
⇒ "1.11 Accident without airbag triggering", page 9
⇒ "1.12 Checking seat belts", page 10
⇒ "1.13 Checking belt webbing", page 10
⇒ "1.14 Checking inertia reel (locking mechanism)", page 11
⇒ "1.15 Visually checking belt buckle", page 11
⇒ "1.16 Checking operation of belt buckle", page 11
⇒ "1.17 Checking belt guide fittings and latch plates", page 12
⇒ "1.18 Checking securing parts and anchorage points after an
accident", page 12
⇒ "1.19 Checking child seat anchors after an accident",
page 12
⇒ "1.20 Safety instructions for automatically dimmable interior
mirror", page 13
1.1 Safety measures when working on ve-
hicles with a start-stop system
Observe the following when working on vehicles with a start-stop
system:
WARNING
Risk of injury due to automatic engine starting in vehicles with
a start-stop system.
♦ In vehicles with an activated start-stop system (indicated
by a message in the dash panel insert), the engine may
start automatically if necessary.
♦ When working on the vehicle, therefore, make sure that
the start-stop system is deactivated (switch off the ignition;
switch the ignition on again if necessary).
2
Rep. gr.00 - Technical data