D-Link DES-3528 User Manual page 215

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
To establish the rule for a previously created CPU Access Profile:
To configure the Access Rules for IP, open the CPU Access Profile List window and click Add/View Rules for an IP
entry. This will open the following window.
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click
the Add Rule button:
To set the Access Rule for IP, adjust the following parameters and click Apply
Parameter Description
Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100.
Action Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this access rule
Name
will be implemented on the Switch.
Ports Ticking the All Ports check box will denote all ports on the Switch.
Figure 10- 40. CPU Access Rule List window for IP
Figure 10- 4 . Add Access Rule window for IP 1
199