Imp Entry Settings - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Max Entry

IMP Entry Settings

This table is used to create Static IP MAC Binding Port entries on the switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Entry Settings
The following fields can be set or modified:
Parameter
IP Address
MAC Address
Mode
Ports
Click Apply for implement changes, click Find to search for an entry, click Show All for the table to display all entries
and click Delete to remove an entry.
trapped by the CPU needs to be forwarded by the software. This setting controls the
forwarding behavior in this situation.
Specifies the maximum number of IP-MAC-Port Binding entries. By default, per port max entry
is 5.
Figure 9- 6. IMP Entry Settings window
Description
Enter the IP address to bind to the MAC address set below.
Enter the MAC address to bind to the IP Address set above.
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP – Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered. If the system is in ARP mode, the arp mode entries and acl mode
entries will be effective. If the system is in the acl mode, only the acl mode entries will be
active.
ACL – Choosing this entry will allow only packets from the source IP-MAC binding entry
created here. All other packets with a different IP address will be discarded by the Switch. This
mode can only be used if the ACL Mode has been enabled in the IMP Global Settings window
as seen previously.
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address). Click the All check box to configure this entry for all ports on the Switch.
131