Port Access Control; Radius Authentication - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
The following fields may be set or viewed:
Parameter
Port
Time Interval
Record Number
ExDefer
CRC Error
LateColl
ExColl
SingColl
Collision
Show/Hide
Clear
View Table
View Graphic

Port Access Control

The following windows are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the Port
Access Control windows, open the Monitoring folder and click Port Access Control. There are seven monitoring
windows in this section.

RADIUS Authentication

This table contains information concerning the activity of the RADIUS authentication client on the client side of the
RADIUS authentication protocol.
To view the RADIUS Authentication window, click Monitoring > Port Access Control > RADIUS Authentication.
Figure 11- 1 . Transmitted (TX) Table window (for errors) 5
Description
Use the drop-down menu to choose the port that will display statistics.
Select the desired setting between 1s and 60s, where "s" stands for seconds. The default
value is one second.
Select number of times the Switch will be polled between 20 and 200. The default value is
200.
Counts the number of packets for which the first transmission attempt on a particular
interface was delayed because the medium was busy.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
Counts the number of times that a collision is detected later than 512 bit-times into the
transmission of a packet.
Excessive Collisions. The number of packets for which transmission failed due to excessive
collisions.
Single Collision Frames. The number of successfully transmitted packets for which
transmission is inhibited by more than one collision.
An estimate of the total number of collisions on this network segment.
Check whether or not to display ExDefer, CRCError, LateColl, ExColl, SingColl, and Collision
errors.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
219