D-Link DES-3528 User Manual page 111

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
The following parameters may be viewed or modified:
Parameter
VLAN ID
VLAN Name
Query Interval (1-65535 sec)
Max Response Time
(1-25 sec)
Robustness Value (1-255)
Last Listener Query Interval
(1-25 sec)
Node Timeout (1-16711450)
Router Timeout
(1-16711450 sec)
Done Timer (1-16711450 sec)
Querier State
Fast Done
Figure 7- 35. MLD Snooping Settings – Edit Window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN for which
to modify the MLD Snooping Settings.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which
to modify the MLD Snooping Settings.
Allows the entry of a value between 1 and 65535 seconds, with a default of 125
seconds. This specifies the length of time between sending IGMP queries.
This determines the maximum amount of time in seconds allowed to wait for a
response for MLD port listeners. The Max Response Time field allows an entry
between 1 and 25 (seconds). Default = 10.
Provides fine-tuning to allow for expected packet loss on a subnet. The user may
choose a value between 1 and 255 with a default setting of 2. If a subnet is expected
to be lossy, the user may wish to increase this interval.
Specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. A value between 1 and
25. The default is 1 second.
Specifies the link node timeout, in seconds. After this timer expires, this node will no
longer be considered as listening node. The user may specify a time between 1 and
16711450 with a default setting of 260 seconds.
Specifies the maximum amount of time a router can remain in the Switch's routing
table as a listening node of a multicast group without the Switch receiving a node
listener report. The user may specify a time between 1 and 16711450 with a default
setting of 260 seconds.
Specifies the maximum amount of time a router can remain in the Switch after
receiving a done message from the group without receiving a node listener report.
The user may specify a time between 1 and 16711450 with a default setting of 2
seconds.
The default is Disabled. If the field displays "Disabled", it will always be in MLD-
Snooping non-querier state.
Used to enable or disable the fast done state of the switch. This field is disabled by
default.
95