Mounting The Switch In A Standard 19" Rack; Power On (Ac Power); Power Failure - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

Mounting the Switch in a Standard 19" Rack

CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.

Power On (AC Power)

Plug one end of the AC power cord into the power connector of the Switch and the other end into the local power
source outlet.
After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators
represents a reset of the system.

Power Failure

As a precaution for AC power supply units, in the event of a power failure, unplug the Switch. When power has
resumed, plug the Switch back in.
Figure 2- 3. Installing the DES-3528 in a rack
8