D-Link DES-3528 User Manual page 168

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Host Name
Host IP
Click Apply to implement changes made.
NOTE: To set the SSH User Authentication parameters on the Switch, a User Account
must be previously configured. For more information on configuring local User Accounts on
the Switch, see the User Accounts section of this manual located in the Configuration
section.
SSH server for authentication purposes. Choosing this parameter requires the user to input
the following information to identify the SSH user.
Host Name – Enter an alphanumeric string of no more than 31 characters to identify
the remote SSH user.
Host IP – Enter the corresponding IP address of the SSH user.
Password – This parameter should be chosen if the administrator wishes to use an
administrator-defined password for authentication. Upon entry of this parameter, the Switch
will prompt the administrator for a password, and then to re-type the password for
confirmation.
Public Key – This parameter should be chosen if the administrator wishes to use the
publickey on a SSH server for authentication.
Enter an alphanumeric string of no more than 32 characters to identify the remote SSH user.
This parameter is only used in conjunction with the Host Based choice in the Auth. Mode
field.
Enter the corresponding IP address of the SSH user. This parameter is only used in
conjunction with the Host Based choice in the Auth. Mode field.
152