D-Link DES-3528 User Manual page 198

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Replace Priority
Replace DSCP
Replace ToS
Precedence
VLAN Name
ICMP
Rx Rate (1-15624)
Time Range Name
Counter
Ports
Click Apply to display the following Access Rule List window.
To view the configurations for previously configured rule click on the corresponding Show Details Button which will
display the following Access Rule Details window.
To configure the IPv6 ACL select IPv6 in the Add ACL Profile window, enter the Profile ID and Profile Name into the
top half of the screen in the Add ACL Profile window and click Select, the following window will appear.
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch.
Enter a replace priority manually if you want to re-write the 802.1p default priority of a packet
to the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field.
Select this option to instruct the Switch to replace the Type of Service as part of the packet
header.
Allows the entry of a name for a previously configured VLAN.
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP)
field in each frame's header.
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
using the following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10
then the ingress rate is 640kbit/sec.) The user many select a value between 1 and 15624 or
tick the No Limit check box. The default setting is No Limit.
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this
access rule will be implemented on the Switch.
Enable or disable the counter settings.
When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and
the access rule will not be configured. Ticking the All Ports check box will denote all ports on
the Switch.
Figure 10- 14. Access Rule List (IPv4)
Figure 10- 15. Access Rule Detail Information
182