D-Link DES-3528 User Manual page 202

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Rx Rate (1-15624)
Time Range Name
Counter
Ports
Click Apply to display the following Access Rule List window.
To view the configurations for previously configured rule click on the corresponding Show Details Button which will
display the following Access Rule Details window.
To configure the Packet Content ACL select Packet Content in the Add ACL Profile window, enter the Profile ID and
Profile Name into the top half of the screen in the Add ACL Profile window and click Select, the following window will
appear.
Precedence bits field in IPv4.
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
using the following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10
then the ingress rate is 640kbit/sec.) The user many select a value between 1 and 15624 or
tick the No Limit check box. The default setting is No Limit.
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this
access rule will be implemented on the Switch.
Enable or disable the counter settings.
When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and
the access rule will not be configured. Ticking the All Ports check box will denote all ports on
the Switch.
Figure 10- 20. Access Rule List (IPv6)
Figure 10- 21. Access Rule Detail Inforamtion (Ipv6)
186