Gigabit Ethernet Technology; Features - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
In addition, the Switch has 2 SFP combo ports. These two-gigabit combo ports are ideal for connecting to a server or
network backbone. This stackable Switch enables the network to use some of the most demanding multimedia and
imaging applications concurrently with other user applications without creating bottlenecks. The built-in console
interface can be used to configure the Switch's settings for priority queuing, VLANs, and port trunk groups, port
monitoring, and port speed.
NOTE: For the remainder of this manual, all hardware versions of the DES-3528 switch will be
referred to as simply the Switch or the DES-3528.

Features

IEEE 802.3 10BASE-T compliant
IEEE 802.3u 100BASE-TX compliant
IEEE 802.1p Priority Queues
IEEE 802.3x flow control in full duplex mode
IEEE 802.3ad Link Aggregation Control Protocol
support.
IEEE 802.1x Port-based and MAC-based Access
Control
IEEE 802.1Q VLAN
IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid
Spanning Tree and IEEE 802.1s Multiple
Spanning Tree support
Access Control List (ACL) support
Single IP Management support
Access Authentication Control utilizing TACACS,
XTACACS and TACACS+
Dual Image Firmware
Simple Network Time Protocol support
MAC Notification support
Asymmetric VLAN support
System and Port Utilization support
System Log Support
Support port-based enable and disable
High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881
packets/sec on each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet
port.
Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to
simultaneously transmit and receive data. It only works with connections to full-duplex-capable end stations
and switches. Connections to a hub must take place at half-duplex
Support broadcast storm filtering
Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
Supports by-port Egress/Ingress rate control.
Supports IP-MAC Port Binding.
Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
Address table: Supports up to 16K MAC
addresses per device
Supports a packet buffer of up to 1 Mbyte
Supports Port-based VLAN Groups
Port Trunking with flexible load distribution and fail-
over function
IGMP Snooping support
SNMP support
Secure Sockets Layer (SSL) and Secure Shell
(SSH) support
Port Mirroring support
MIB support for:
RFC1213 MIB II
RFC1493 Bridge
RFC1757 RMON
RFC1643 Ether-like MIB
RFC2233 Interface MIB
Private MIB
RFC2674 for 802.1p
IEEE 802.1x MIB
RS-232 DCE console port for Switch management
Provides parallel LED display for port status such
as link/act, speed, etc.
2