D-Link DES-3528 User Manual page 199

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry enter the correct information and click Create. To return to the Access Profile List page click Back.
The following parameters can be set, for IPv6:
Parameter
IPv6 Class
IPv6 Flow Label
IPv6 Address
Click Apply to implement changes made.
Click Create to view the new Access Profile List entry in the Access Profile List table shown below. To add another
Access Profile click Add ACL Profile. To delete a profile click the corresponding Delete button, to view the specific
configurations for an entry click the Show Details button. To add a rule to the Access Profile entry, click the
Add/View Rules button.
Figure 10- 16. Add IPv6 ACL Profile
Description
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. This flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
IPv6 Source Address – Enter an IPv6 address to be used as the source address.
IPv6 Destination Address – Enter an IPv6 address that will be used as the destination
address.
NOTE: At any one time the user can only choose IPv6 class and
IPv6 Flow Label together or IPv6 Address by itself.
183