Web-Based Access Control Settings - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
6. If a RADIUS server is to be used for authentication, the user must first establish a RADIUS Server with the
appropriate parameters, including the target VLAN, before enabling the Web-based Access Control on the
Switch.

Web-based Access Control Settings

To configure the Switch for Web Authentication Settings, open the Security > Web Authenication > Web-based
Access Control Settings
To set the Web-based Access Control for the Switch, complete the following fields:
Parameter
State
Method
Logout Timer
(1-1440)
VLAN
Figure 9- 45. Web-based Access Control Settings
Description
Toggle the State field to either Enable or Disable for the Web-based Access Control settings
of the Switch.
Use the pull-down menu to choose the authenticator for Web-based Access Control. The user
may choose:
local – Choose this parameter to use the local authentication method of the Switch as the
authenticating method for users trying to access the network via the switch. This is, in fact, the
username and password to access the Switch configured using the User Account Creation
screen seen below.
radius – Choose this parameter to use a remote RADIUS server as the authenticating method
for users trying to access the network via the switch. This RADIUS server must have already
been pre-assigned by the administrator using the RADIUS Server window located in the
802.1x section.
The logout time in displayed in minutes, enter a value between 1 and 1440.
Enter the VLAN name which users will be placed while authenticated by the Switch or a
RADIUS server This VLAN should be pre configured to have limited access rights to web
165