Imp Global Settings; Imp Port Settings - D-Link DES-3528 User Manual

Xstack
Hide thumbs Also See for DES-3528:
Table of Contents

Advertisement

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

IMP Global Settings

This window is used to enable or disable the ACL mode, Trap Log State and DHCP Snoop state on the switch. When
the user enables the ACL Mode for IP-MAC Binding it will create two Access Profile Entries on the Switch. The
Trap/Log field will enable and disable the sending of trap log messages for IP-MAC binding. When enabled, the
Switch will send a trap message to the SNMP agent and the Switch log when an ARP packet is received that doesn't
match the IP-MAC binding configuration set on the Switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Global Settings
The following parameters can be set:
Parameter
ACL Mode
Trap / Log
DHCP Snoop State
Click Apply to implement the settings made.

IMP Port Settings

Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with the State, Allow
Zero IP and Forward DHCP packet field, and configure the port's Max entry.
To view this window click, Security > IP-MAC-Port Binding > IMP Port Settings
Figure 9- 4. IMP Global Settings window
Description
This field will enable and disable the ACL mode for IP-MAC binding on the Switch, without
altering previously set configurations. When enabled, the Switch will automatically create two
ACL packet content mask entries which will aid the user in processing certain IP-MAC binding
entries created. The ACL entries created when this command is Enabled can only be
automatically installed if the Access Profile table has two entries available of the possible six
entries allowed.
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log
when an ARP packet is received that doesn't match the IP-MAC binding configuration set on
the Switch.
Use the pull-down menu to enable or disable the DHCP Snoop State for IP-MAC Binding.
129

Advertisement

Table of Contents
loading

Table of Contents