Control Panel Layout - Dukane VWA-4300 User Manual

Control Panel Layout

The control panel contains all of the switches, indicator
lights and the display to set up and operate the vibration
welder.
The control panel is shown in Figure 4-1. Brief explana-
tions of the primary panel controls are given below.
A Color Touch–Screen Display
This touch screen uses color active matrix thin–film transis-
tors (TFT) for high contrast and wide viewing angle even
under high ambient lighting conditions.
The display provides for all monitoring and programming
of the weld cycle.
Refer to Section 6 - Touch Screen Menus for information
about the function of the various menus.
B Main Power
When the main AC switch is turned on, this light is ener-
gized by the power supply, and it lights up. When this is
MAIN POWER
lit, indicates the +24V control power
supply is ready.
C In Cycle
(light)
IN CYCLE
The green
RUN
welder is in the
welder has started a weld cycle.
When the weld cycle is done, the flashing stops and a
steady green appears. The light goes out when the welder
SETUP
is switched to
D Alarm
(light)
ALARM
The red light flashes during any kind of alarm
E-STOP
condition such as the
when a service door is open. The light flashes in either the
RUN SETUP
or modes, and continues to flash, until the
alarm condition has been cleared.
Dukane Manual Part No. 403-592-00
(light)
light is lit whenever the vibration
mode. The light flashes when the
mode.
button being pushed or
Section 4 - Display and Controls

Control Panel Layout

Figure 4-1
Page 27