Table of Contents
Advertisement
Operational Switches
Opti-touch Operate
Switch (2)
Operate Switch, Vacuum, and E-Stop Buttons, Light Curtains, and Utility Outlet Locations
Figure 4-2
Opti-Touch Operate Switches
H
Located directly in front and below the sliding access
door are two small mounting boxes that each contain an
OPERATE
optical
switch. Their placement is shown in
Figure 4-2.
These identical switches use Infrared (IR) sensors.
They comply with OSHA and CE safety standards. The
operator can begin a weld cycle using either the left or the
right switch alone.
Each optical-touch switch has a small red
front illuminated whenever the power is on, as shown in
Figure 4-3 and 4-5. When the operator places his finger in
the tray, a second
LED
indicate the switch has been activated.
Dukane Manual Part No. 403-592-00
E-Stop (2)
LED
at the right rear also illuminates to
Vacuum Button
G G
Figure 4-3
in the left
Figures represent typical hardware and
placement but may not show individual cus-
tom options.
Section 4 - Display and Controls
Light Curtain (2)
AC Utility
Outlet
E-STOP
Button
Left Operate and E-STOP Button
NOTE
Page 29
Advertisement
Chapters
Table of Contents
