Dukane VWA-4300 User Manual page 77

Utilities > I/O Setup > Valves
sensors associated with the welder's tooling are
programmed through I/O Setup.
Figure 6-31 Utilities Screen - I/O Setup > Valve
Valves – In Figure 6-31 above, Valve 1 is programmed to
AT
extend CYCLE START, and it will retract AT END
OF HOLD. The table below shows the selection possibili-
ties for Extend and for Retract.
Extend
OFF - Disabled
AT CYCLE START
AT DOOR CLOSED
AT TABLE HOME
AT EJECT
AT START OF WELD
PART LOCATORS
Valve Extend, Retract Selections
Table 6-I
Dukane Manual Part No. 403-592-00
Continued from Previous Page
- Valves and
Retract
AT START OF HOLD
AT END OF HOLD
AT TABLE HOME
AT DOOR OPEN
AT START OF WELD
Section 6 - Touch Screen Menus
Continued
Page 71