Front Panel Overview; Front Panel; Power Switch; Control Keys - Dukane iQ Series User Manual

Front Panel Overview

This section gives an overview of the front panel functions:
powering the generator on/off; monitoring the process with
the display; and, programming with the control keys.
LCD Display
Figure 4-1 Front Panel
Power Switch/Circuit Breaker
The power switch/circuit breaker has a rocker type actua-
tor switch that will activate or deactivate the AC power
to the system. The power ON position is marked with the
internationally recognized I symbol, the power OFF posi-
tion is marked with the 0 symbol. This power switch also
integrates an appropriately sized over-current protection
circuit breaker function in the generator.
If an over-current condition trips the circuit breaker, it will
automatically switch to the OFF position. If the overload
current that caused the circuit breaker to trip is due to a
transient condition, the circuit breaker can be reset by
switching the actuator back to the ON position. If when
resetting the circuit breaker after it has tripped, it imme-
diately trips again, there is likely an internal system mal-
function, and the generator will require service.
Do not repeatedly try to reset the circuit breaker. If it trips,
this will only cause more damage to the generator.
Dukane Manual Part No. 403-577-00
Section 4 – Controls and Connections

Control Keys

Control Keys
The control keys shown in Figure 4-1 and described
below, are used to display information, and to program
the generator.
INFO
Press this key to get system information or to modify the
hardware settings.
System Information -
version of system software.
Hardware Settings -
turned on or off including the Audible Alarm or Fault
Latching options.
SETUP
Use the SETUP key to Load, Store, or Delete as many as
eight setups.
Power
Switch
Identifies the current
Select features that can be
Page 7