Dukane VWA-4300 User Manual page 88

Linear Vibration Welder 4000 Series, Model VWA User's Manual
Utilities > PLC I/O Status
On the Utilities Screen, press the PLC I/O Status
button. Figure 6-42 below shows what the pop-up
window looks like. In this view the user can see the on/
off states of Digital I/O and the numeric values of Analog
I/O. Inactive PLC addresses will be GRAY and read Off.
Active addresses will be GREEN and read On.
The push buttons and indicator lights at the bottom of the
page are used for manual control of the labeled devices.
Manual control is only active in Setup mode; buttons are
disabled in Run mode.
Figure 6-42 PLC I/O Screen
Table and Door Buttons
Four buttons for moving the table up and down and for
opening and closing the front door are all conveniently
located at the bottom of this pop-up window as shown in
Figure 6-42 above.
Page 82
NOTE
Table Up, Table Down, Door Open, and
Door Close buttons are active only when
Setup Mode is active. The buttons are
disabled in Run Mode.
Dukane Manual Part No. 403-592-00
Press button to
close the pop-up
window.