Touch Screen Banner; Alarm Detected; Door Out Of Position; Hydraulics Off - Dukane VWA-4300 User Manual

Touch Screen Banner

The table below shows all the messages that display
in the banner position - at the top of the various touch
screen menus
.
Local Message Display

Alarm Detected

Door out of Position

Hydraulics Off

In Cycle

Invalid Tool ID

Light Curtain is Obstructed

Machine Ready for Cycle

Machine Ready for Setup

Remove Welded Part

Table Not in Load Position

Waiting for Part and Place Sensors

Touch Screen Banner Messages
Table 6-III
Dukane Manual Part No. 403-592-00
Interpretation
One or more alarms have been detected.
Front door is not in the Home position.
The hydraulic unit is off.
The machine is in RUN MODE and actively in a cycle.
Tool ID is enabled, but an invalid ID was detected.
An object has been detected in the detection zone, or light curtains
are misaligned.
Everything is OK and ready for a cycle
Machine is ready for manual operations.
A part has been processed and waiting to be removed.
Table is not in the start position.
One or more part presence sensors are enabled but don't detect
the presence of a part. The machine will not cycle until the part is
detected.
Section 6 - Touch Screen Menus
Page 91