Pre-Pick - Fujitsu FI-5900C Operator's Manual
Image scanner
Hide thumbs
Also See for FI-5900C:
- Operator's manual (257 pages) ,
- Getting started (30 pages) ,
- Consumable replacement and cleaning instructions (24 pages)
Table of Contents
Advertisement
8.8 Pre-Pick
To scan documents consecutively, you can previously pick the document to be scanned next. This opera-
tion is called Pre-Pick.
By enabling Pre-Pick, the time interval between the scanning of two separate documents can be shortened.
Configure the settings for the Pre-Pick as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select [Device Setting 2] from left side list in the window, and select [Pre-
Pick] from its lower level.
3.
Select "Yes" or "No" for Pre-Pick.
Select "Yes" to make Pre-pick valid, and select "No" to make it invalid.
HINT
188
8.8 Pre-Pick
170.
By enabling Pre-Pick, faster scanning can be achieved.
While Pre-Pick is valid, if you cancel scanning in process, you have to re-
load the document after ejecting all the pre-picked document.
• This setting is also available by device driver setting. In this case device
driver setting has a priority to the setting by this section.
Advertisement
Table of Contents
