Shortening The Scanning Intervals [Pre-Pick] - Fujitsu fi-7800 Operator's Manual

Shortening the Scanning Intervals [Pre-Pick]

"Pre-Pick" refers to feeding the document to the starting position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning each document.
1
Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page
2
From the listing on the left, select [Device Setting 2] → [Pre-Pick].
3
Specify whether or not to enable pre-pick.
Select [Yes] to enable and [No] to disable Pre-pick.
HINT
● If you cancel in the middle of scanning while Pre-Pick is enabled, you will have to remove the pre-picked
document, then load the document again.
● This setting can also be configured in the scanner driver's setup dialog box. Note that priority is given to
the scanner driver setting.
193).
231
Operational Settings