Shortening The Scanning Intervals [Pre-Pick] - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings

Shortening the Scanning Intervals [Pre-Pick]

"Pre-pick" refers to feeding the document to the starting
position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning
each document.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Pre-Pick].
3
Select [Yes] or [No].
If you cancel in the middle of scanning while pre-pick
is enabled, you will have to remove the pre-picked
document, then load the document again.
This setting can also be configured from the scanner
driver's setup dialog box. Note that priority is given to
the scanner driver setting.
153).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
174