Scanning Does Not Start - Fujitsu fi-6800 Operator's Manual

Chapter 7 Troubleshooting

Scanning does not start.

Are the documents set on the hopper correctly?
Yes
Is the ADF closed properly?
Yes
Is the interface cable connected correctly?
Yes
Is the connector on the interface cable broken?
No
Is the SCSI ID configured correctly?
(when connected via SCSI cable)
Yes
Does the scanning start after turning the scanner back on?
No
Reload the documents on the hopper.
No
Remove documents from the hopper, then open and close the ADF.
No
Connect the interface cable properly.
For information on how to connect the cables, refer to "Connecting Cables" in
No
"Getting Started".
Use a new interface cable.
Yes
Turn off the scanner and the computer. Then specify a correct SCSI ID, turn the
scanner back on, and restart the computer.
No
For information on how to configure the SCSI ID, refer to [Connecting Cables] in
"Getting Started".
The scanner is operating normally.
Yes
If the above countermeasures do not solve the problem, check the items in
Before You Contact the Scanner Service Provider" (page 128)
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
"7.4
first, then contact
Operational
Settings
Appendix
Glossary
117