Auerswald COMpact 5010 VoIP Configuration Manual page 89

HW requirements
SW requirements Version 3.0C (PBX)
Dongle release – – –
Configuration via / Administration
Setting via
For explanations concerning the table, see
Configuration of the Feature
Enable DiffServ on the PBX. (Administration
Enabling DiffServ sets the following DSCP values for VoIP calls (as
suggested in RFC 4594):
Signalling (SIP): CS5
Voice (RTP): EF
Dependency/Limitations
Support for DiffServ must be enabled and available on all active
network components.
Normally, DiffServ is not supported by VoIP providers. This means
that on the Internet, this setting may not be taken into consideration
under certain circumstances.
COMpact 5010 VoIP/5020 VoIP - Firmware version 4.0 - Configuration Manual 06 08/11
Features – Function and Configuration
Server configuration
page 39
Server configuration).
Features – Function and Configuration
Voice over IP (VoIP)
89