Auerswald COMpact 5010 VoIP Configuration Manual page 17

Assigning Group Members (with Ringer Delay)
Assign members to the available groups.
To do this, open the page displayed in the fig-
ure to the right.
Under "Please select a group:", select the
group to be configured first from the list field.
In the column "Telephone number / name"
under "from: until:", select all the subscribers
and groups from the list fields that should be
called when the group is called.
Then click "Execute" to apply the settings to
the PBX.
If some of the group members should get a
delayed call when the group is called, activate
this under "Ringing delay (is only valid for
ringing sequence "all")".
Then click "Execute" to apply the settings to
the PBX.
Configure the settings for all additional
groups.
This completes group creation.
Note: The ringer delay time set to 5 seconds can be changed on
page COMset Internal numbers
ure Reachability. You also have the option of selecting other ring-
ing sequences (for more on this, refer to
page 66).
When a group is created, the existing settings under "Status of
inbound/outbound calls" do not need to be changed for the call dis-
tribution to be correct (see also
COMpact 5010 VoIP/5020 VoIP - Firmware version 4.0 - Configuration Manual 06 08/11
The figure shows you the following page with the settings for
COMset
Groups Properties
Ringing Sequence on
Assign, Log in, Log out on page 65
Configuration Manual
Example 1: Basic Configuration with Internal Subscribers and Call Distribution
Internal numbers Groups
During configuration using the configuration assistant, groups are
Config- automatically created and – depending on the call distribution – group
members are assigned. On this page, you can delete subscribers and
groups that should no longer be called when the group is called. Click
the red recycle bin in the corresponding table line and, subsequently,
click the green check mark below. Or under "Action", configure
Delete and select the group members to be deleted from the group in
the left column. Then click "Execute".
).
Configuration Manual
Example 1 on page
Group members
12:
17