Auerswald COMpact 5010 VoIP Configuration Manual page 24

Configuration Manual
Configuration Manual
Example 1: Basic Configuration with Internal Subscribers and Call Distribution
Call Distribution on VoIP Point-to-Point Connections
In the PBX, configure the linear call distribu-
tion as well as the call distribution that devi-
ates from it for the extension range entered.
To do this, open the page displayed in the
figure to the right.
Under "Call distribution for ...", select "VoIP
point-to-point connections" from the list
field.
Under "VoIP point-to-point connection",
select one of the VoIP accounts with a Point-
to-Point connection from the list field that has
already been configured.
Under "Linear call distribution (external =
internal)", enable linear call distribution (it is
enabled by default).
Under "DDI", enter – if available – one of the
DDIs which deviates from the linear call
distribution.
Under "Internal no. | name", select an internal telephone number for
the registered DDI from the list field.
Click "Execute" to accept the settings in the PBX.
Enter additional DDIs that deviate from the linear call distribution and
select the associated internal telephone numbers.
Note: Telephone numbers that diverge from the linear call
distribution must be found in the DDI number block entered.
For more information on this subject, refer to
Reachability on page 40.
24
The figure shows you the following page:
COMset External numbers
Call Distribution and
COMpact 5010 VoIP/5020 VoIP - Firmware version 4.0 - Configuration Manual 06 08/11
Voice over IP (VoIP) Call distribution