Auerswald COMpact 5010 VoIP Configuration Manual page 68

Features – Function and Configuration
Group/Team Functions
C. a. y. "Adding - fixed - Split Group"
One call:
0 20 40 60
T1
T2
T3
T4
One call (CF on no Reply active to target telephone T5):
0 20 40 60
T1
T2
T3
T4
T5
Two calls A and B
0 20 40 60
T1
T2
T3
T4
C. b. y. "Adding - balancing - Split Group"
(This is different than "Adding - fixed - Split Group" due to the
changing priorities only,)
68
Features – Function and Configuration
80 100 120 seconds
80 100 120 seconds
(call B starts 30 seconds delayed):
80 100 120 seconds
C. a. x. y. "Adding - fixed - rotating - Split Group"
One call:
0 20 40
T1
T2
T3
T4
One call (CF on no Reply active to target telephone T5):
0 20 40
T1
T2
T3
T4
T5
Two calls A and B
0 20 40
T1
T2
T3
T4
C. b. x. y. "Adding - balancing - rotating - Split Group"
(This is different than "Adding - fixed - rotating - Split Group" due to
the changing priorities only.)
Use/Check of Features
1. Configure a group with several members.
2. Log in all members into the group.
3. Call the group from another telephone. Keep the call ringing to
check the ringing sequence.
Dependency/Limitations
If a group (subgroup) has been configured as member of a group
(main group), the following special rules apply:
If a subscriber is at the same time member of the main group and of
the subgroup, he will only be considered as a member of the main
group when a call comes in.
The ringing scheme configured for the specific group applies. If the
same ringing schemes have been configured for the main group and
the subgroup, the subscribers will behave as if they were members of
a single large group. If, for example, "Linear" has been set for the
main group and "All" for the subgroup, the members of the main
group will ring one after the other and the members of the subgroup
(as soon as it is their turn) will ring simultaneously.
In the case of a second call to the main group, it will be checked both
for the main group and for the subgroup whether splitting is possible
("Split Group"). If this is the case, the subgroup will be considered for
both calls and the members of the subgroup will be divided among
both calls.
CF on no Reply configured for a group (COMset
Groups Properties
field at the top) is started after the configured CF delay time. As soon
as the CF target is called, the group call is terminated.
COMpact 5010 VoIP/5020 VoIP - Firmware version 4.0 - Configuration Manual 06 08/11
60 80 100 120 seconds
60 80 100 120 seconds
(call B starts 30 seconds delayed):
60 80 100 120 seconds
Internal numbers
Call Forwarding + group selection in the list