Auerswald COMpact 5010 VoIP Configuration Manual page 23

If additional ISDN Point-to-Multipoint connections are present, under
"ISDN Point-to-multipoint connection", select the next Point-to-
Multipoint connection from the list field and configure the settings for
it.
Call Distribution on an ISDN Point-to-Point Connection
In the PBX, configure the linear call distribu-
tion as well as the call distribution that devi-
ates from it for the extension range entered.
To do this, open the page displayed in the fig-
ure to the right.
Under "Call distribution for ...", select from
the list field „ISDN Point-to-point connec-
tions".
Under "ISDN Point-to-point connection",
select one of the Point-to-Point connections
already configured from the list field.
Under "Linear call distribution (external =
internal)", activate linear call distribution (it is
active by default).
Under "DDI", enter – if present – one of the
DDIs which deviates from the linear call distri-
bution.
Under "Internal no. | name", select an inter-
nal telephone number for the registered DDI
from the list field.
Then click "Execute" to apply the settings to
the PBX.
Enter additional DDIs that deviate from the linear call distribution and
select the associated internal telephone numbers.
Call Distribution on VoIP Point-to-Multipoint Connections
On the PBX, configure the associated internal
telephone number for each MSN entered.
To do this, open the page displayed in the
figure to the right.
Under "Call distribution for ...", select "VoIP
point-to-multipoint connections" from the
list field.
Under "VoIP point-to-multipoint
connection", select one of the VoIP accounts
with Point-to-Multipoint connection from the
list field that has already been configured.
Under "Multiple Subscriber Number (MSN)
| Display Name", you will find a list of the
MSNs available for this VoIP account.
Under "Internal no. | name", select an
internal telephone number for each MSN from
the list fields.
Click "Execute" to accept the settings in the
PBX.
This completes call distribution configuration on the VoIP Point-to-
Multipoint connection.
If other VoIP accounts with a Point-to-Multipoint connection are
available, under "VoIP point-to-multipoint connection", select the
next VoIP account from the list field and configure the settings for it.
Note: For more information on this subject, refer to
and Reachability on page 40.
COMpact 5010 VoIP/5020 VoIP - Firmware version 4.0 - Configuration Manual 06 08/11
Example 1: Basic Configuration with Internal Subscribers and Call Distribution
Note: For more information on this subject, refer to
and Reachability on page
The figure shows you the following page with the settings for
COMset External numbers
Note: Telephone numbers that diverge from the linear call distribu-
tion must be found in the DDI number block entered.
For more information on this subject, refer to
Reachability on page
The figure shows you the following page with the settings for
COMset External numbers
Call Distribution
Configuration Manual
40.
ISDN connections Call distribution
40.
Voice over IP (VoIP) Call distribution
Configuration Manual
Call Distribution
Example 1 on page 12:
Call Distribution and
Example 1 on page 12:
23