Preparing Heaters; Changing Temperature Settings Of The Heater - MIMAKI UJV-160 Operation Manual

Preparing Heaters

Set the heater temperature according to the media used.

Changing temperature settings of the heater

The temperature of the heater can be changed by [HEATER] of the setup mode.
( P.3-11 "Changing the heater temperature setting")
• When purchased, the heater temperature is set "OFF".
• Since the temperature can be adjusted in drawing, you can set the proper temperature.
• Depending on the environmental temperature, it may take several minutes to several ten minutes to
reach the set temperature.
When <LOCAL> is displayed, press the
1
Press the
2
Set the each temperature of the heater
3
with the
press the
Heating of the heater starts.
4
Heating ends.
5
Press the
6
2-30
Downloaded From ManualsPrinter.com Manuals
key.
HEATER
HEATER
key.
ENTER
• Select the heater with the
• Set the temperature with the
• The [HEAT] lamp lights in orange.
• When the heater reaches the set temperature, the [HEAT] lamp goes out, then the
[CONSTANT] lamp lights in green.
key to finish.
ENTER
key.
keys, and
keys.
keys.
< L OCA L . 1 >
PRE PR T
3 5 ° C 4 0 ° C
Heater temperature
confirming display
The set temperature ： 20 to 50°C
4 0 ° C 4 0 ° C
( OF F OF F
Temperature set in [HEATER]
of each type in the [SET UP].
)