Table of Contents
Advertisement
Preparing Heaters
Changing temperature settings of Heater
The set temperature of Heater can be changed and stored by [HEATER] of the setup mode. (
The adjusting procedures of the temperature set in the setup mode are described below.
Set the Heater temperature according to the media used.
• The Heater temperature has been set to "OFF" when purchased.
• Proper temperature adjustment is enabled since the temperature is adjustable even in drawing.
• It may take several minutes to several ten minutes to reach the set temperature depending on the environmental
temperature.
1
Press the
2
Press the
3
Set the temperature of each Heater by pressing the
Heater selecting
Temperature setting : Set with the
• Heating of Heater starts. (The [HEAT] lamp lights in orange.)
4
Heater heating ends.
• The [HEAT] lamp goes out then the [CONSTANT] lamp lights in green when the Heater temperature
reaches the set temperature.
5
Press the
• It returns to the local mode.
• The Heater temperature is registrable beforehand according to the media to be used.
• The temperature set by the operations above does not reflect the Heater set temperature of the type
registration. The set continues until the power is turned off or the temperature is newly set according to
the following conditions.
(1) Change the type of the setup mode.
(2) Change the Heater temperature of the setup mode.
(3) Designate the Heater temperature from the PC.
• The Heater temperature is controllable at the RIP side if the RIP in use has a function controllable.
(For the setting procedures, refer to the instruction manual of the RIP in use.)
• Use this machine under 20 to 35°C. The temperature may not reach the set value due to the
environmental temperature condition.
2-30
Downloaded From ManualsPrinter.com Manuals
key.
key.
keys.
: Select with the
key to end.
P.3-2 "Registering the drawing conditions together (Type registration)"
keys
keys
P.3-8)
PRE
PR T
POS T
3 5 ° C
4 0 ° C
5 0 ° C
Heater temperature
confirming display
4
0
° C
4
0
° C
5
0
° C
( OF F
OF F
OF F
Temperature set in [HEATER]
of the type registration
The set temperature: 20 to 50°C
4
0
° C
4
0
° C
5
0
° C
( OF F
OF F
OF F
)
)
Advertisement
Table of Contents
