Kubota M6800S Workshop Manual page 172

M6800 · M6800S · M8200 · M9000, WSM
Piping for 3-Point Hydraulic System
1. Remove the accelerator rod (1).
2. Remove the suction pipe (3).
3. Remove the delivery pipe (4) for 3-point hydraulic system.
4. Remove the delivery pipe (2) for power steering.
(1) Accelerator Rod
(2) Delivery Pipe
(3) Suction Pipe
(4) Delivery Pipe
Wire Harness R.H. and Fuel Pipes
1. Disconnect the 3P connector for solenoid valve (3).
2. Disconnect the wiring lead (2) from the glow plug.
3. Disconnect the coolant thermo sensor 1P connector (1).
4. Remove the fuel pipes (4).
(1) Coolant Thermo Sensor 1P
Connector
(2) Wiring Lead for Glow Plug
Wire Harness L.H.
1. Disconnect the alternator 2P connector (1) and B terminal (2).
2. Disconnect the starter motor C terminal (5) and B terminal (4).
3. Disconnect the engine oil pressure switch terminal (3).
4. Remove the earth wire (6).
(When reassembling)
Starter's terminal B
Tightening torque
mounting nut
(1) Alternator 2P Connector
(2) Alternator B Terminal
(3) Engine Oil Pressure Switch Terminal
2-S7
CLUTCH
(A) Individual Flow Type
(B) Combined Flow Type
W1013791
(3) 3P Connector for Solenoid Valve
(4) Fuel Pipes
W1013985
8.8 to 11.8 N·m
0.9 to 1.2 kgf·m
6.5 to 8.7 ft-lbs
(4) Starter Motor B Terminal
(5) Starter Motor C Terminal
(6) Earth Wire
W1014131
KiSC issued 03, 2008 A