Kubota M6800S Workshop Manual page 182

M6800 · M6800S · M8200 · M9000, WSM
PTO Clutch Valve
1. Remove the differential lock pedal (3).
2. Disconnect the PTO clutch valve cable (2).
3. Remove the PTO clutch valve (1).
(When reassembling)
• Apply transmission fluid to O-ring.
• Remove the two hydraulic pipes from the PTO clutch holder.
• Insert both the hydraulic pipes into the PTO clutch valve holes
down to the bottom.
• Now while aligning the hydraulic pipe ends with the PTO clutch
holder holes, assemble the PTO clutch valve (1) to the
transmisison case.
PTO clutch valve mounting
Tightening torque
screw
(1) PTO Clutch Valve
(2) PTO Clutch Valve Cable
PTO Clutch and Holder
1. Remove the PTO clutch holder mounting screws.
2. Remove the PTO clutch (4) with holder.
(When reassembling)
• Apply transmission fluid to O-ring.
• Take care not to damage the hydraulic pipes (1).
PTO clutch holder
Tightening torque
mounting screw
IMPORTANT
• When reassembling the PTO clutch assembly, direct the
projection part of brake plate (A) as a figure [M6800(S)].
• After assembling the PTO clutch assembly, be sure to check
the piston operation by air-blowing.
(1) Hydraulic Pipe
(2) Holder
2-S17
CLUTCH
23.5 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(3) Differential Lock Pedal
W1023008
23.5 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(3) Brake Plate
(4) PTO Clutch Pack
W1023169
KiSC issued 03, 2008 A