Kubota M6800S Workshop Manual page 254

M6800 · M6800S · M8200 · M9000, WSM
Differential Lock Fork [M8200 · M9000]
1. Remove the differential lock rod (1).
2. Remove the clevis pin (3) and plug (6).
3. Draw out the differential lock shaft (5).
4. Take out the differential lock fork (4) and spring (2).
(When reassembling)
• Apply grease to the oil seal.
(1) Differential Lock Rod
(2) Spring
(3) Clevis Pin
(4) Differential Lock Fork
Differential Gear Assembly [M6800(S)]
1. Remove the differential support (1), (5), noting the number of left
and right shims (2), (4).
2. Take out the differential gear assembly (3) from transmission
case.
(When reassembling)
• Be sure to adjust the turning torque of spiral bevel pinion shaft
and differential assembly combined. (See page 3-S50, S51.)
• Be sure to adjust the backlash and tooth contact between the
spiral bevel gear and spiral bevel pinion shaft. (See page 3-S52,
S53.)
• When installing the differential support to the transmission, be
sure to reassemble it as shown in the figure.
Differential bearing support
Tightening torque
mounting screw
(1) Differential Support
(2) Shim
(3) Differential Assembly
(4) Shim
3-S43
TRANSMISSION
(5) Differential Lock Shaft
(6) Plug
(7) Shim
(8) Differential Lock Clutch
W1025234
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
(5) Differential Support
(6) Oil Hole
(7) Oil Hole
W1025952
KiSC issued 03, 2008 A