Kubota M6800S Workshop Manual page 34

M6800 · M6800S · M8200 · M9000, WSM
Checking Engine Start System [M6800]
CAUTION
• Do not allow anyone near the tractor while testing.
• If the tractor does not pass the test, do not operate the
tractor.
Preparation before testing
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
Test 1 : Switch for the range gear shift lever.
1. Sit on operator's seat.
2. Shift the range gear shift lever (1) to the desired position.
3. Depress the clutch pedal (2) fully.
4. Disengage the PTO clutch control lever (3).
5. Pull out the engine stop knob and turn the key to "START"
position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
Test 2 : Switch for the PTO clutch control lever.
WARNING
• Disconnect the implement drive universal joint from the PTO
shaft, if the implement has mounted.
1. Sit on operator's seat.
2. Engage the PTO clutch control lever (3).
3. Depress the clutch pedal (2) fully.
4. Shift the range gear shift lever (1) to the neutral position.
5. Pull out the engine stop knob and turn the key to "START"
position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
(1) Range Gear Shift Lever
(2) Clutch Pedal
G-19
G GENERAL
(3) PTO Clutch Control Lever
W1023076
KiSC issued 03, 2008 A