Kubota M6800S Workshop Manual page 173

M6800 · M6800S · M8200 · M9000, WSM
Propeller Shaft (4WD Only)
1. Slide the propeller shaft cover (3), (5) after removing the screws
(6).
2. Tap out the spring pin (2), (4) and then slide the coupling (1), (8)
to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
Separating Engine from Clutch Housing
1. Check the engine and clutch housing case are securely mounted
on the disassembling stands.
2. Remove the engine mounting screws and nuts, and separate the
engine from the clutch housing.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Apply liquid gasket (Three Bond 1141, 1211 or equivalent) to joint
face of the engine and clutch housing.
Engine and clutch housing
mounting screw, nut
Tightening torque
Engine and clutch housing
mounting stud bolt
2-S8
CLUTCH
(5) Propeller Shaft Cover
(6) Screw
(7) Propeller Shaft
(8) Coupling
W1014346
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
38.2 to 45.1 N·m
3.9 to 4.6 kgf·m
28.2 to 33.3 ft-lbs
W1014594
KiSC issued 03, 2008 A