Kubota M6800S Workshop Manual page 223

M6800 · M6800S · M8200 · M9000, WSM
Floor Mat and Housing Cover
1. Remove the floor mat (1).
2. Remove the housing cover (2).
(1) Floor Mat
Pedal Frame [M6800 · M8200· M9000]
1. Disconnect the brake rods (3) (RH and LH).
2. Disconnect the clutch rod (2).
3. Disconnect the shuttle rod (5). [M8200 · M9000 only]
4. Remove the delivery pipe (4) for PTO clutch.
5. Remove the pedal frame (1) with wire harness.
IMPORTANT
• After reassembling the pedal frame, be sure to adjust the
brake pedal travel and clutch pedal free travel.
(When reassembling)
• Be sure to adjusting the shuttle shift rod.
Pedal frame mounting
Tightening torque
screw
Shuttle rod length (A) Factory spec.
(1) Pedal Frame
(2) Clutch Rod
(3) Brake Rod
Pedal Frame [M6800S]
1. Disconnect the brake rods (3).
2. Disconnect the clutch rod (1).
3. Remove the shuttle rod (4).
4. Remove the pedal frame (2) and steering controller assembly as
a unit.
(When reassembling)
• Be sure to adjusting the shuttle shift rod.
Shuttle shift rod length L Factory spec.
IMPORTANT
• After reassembling the pedal frame, be sure to adjust the
brake pedal play and clutch pedal free travel.
(1) Clutch Rod
(2) Pedal Frame
3-S12
TRANSMISSION
(2) Housing Cover
W1013885
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
268 mm
10.55 in.
(4) Delivery Pipe
(5) Shuttle Rod
(a) M8200, M9000
W1014010
Approx. 160 mm
6.3 in.
(3) Brake Rod
(4) Shuttle Rod
W1096522
KiSC issued 03, 2008 A