Check Points Of Every 800 Hours - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

[9] CHECK POINTS OF EVERY 800 HOURS

Changing Front Differential Case Oil
1. To drain the used oil, remove the drain and filling plug (1), (2) at
the front differential case and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug (1).
3. Remove the oil level check plug (3).
4. Fill with the new oil up to the lower rim of check plug port.
(See "5. LUBRICANTS, FUEL AND COOLANT" at GENERAL
Section.)
5. After filling reinstall the filling plug (2) and check plugs (3).
M6800(S)
M8200
Oil capacity
M9000
(1) Drain Plug
(2) Filling Plug
Changing Front Axle Gear Case Oil
1. To drain the used oil, remove the right and left drain plugs (2) and
filling plugs (1) at the front axle gear case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the filling plug port.
(See "5. LUBRICANTS, FUEL AND COOLANT" at GENERAL
Section.)
4. After filling reinstall the filling plugs (1).
Oil capacity
(1) Filling Plug
Adjusting Front Axle Pivot
1. If the front axle pivot pin adjustment is not correct, front wheel
vibration can occur causing vibration in the steering wheel.
Adjusting Procedure
1. Loosen the lock nut (2), tighten the adjusting screw (1) with
specified torque. Then tighten the lock nut (2).
Adjusting screw
Tightening torque
Lock nut
(1) Adjusting Screw
Replacing Hydraulic Oil Filter
• See page G-17.
Adjusting Engine Valve Clearance
1. See page 1-S19.
G-29
G GENERAL
5.0 L
5.3 U.S.qts.
4.4 Imp.qts.
6.0 L
6.3 U.S.qts.
5.3 Imp.qts.
(3) Check Plug
W1027428
3.5 L
3.7 U.S.qts.
3.1 Imp.qts.
for each side
(2) Drain Plug
W1027622
19.6 to 29.4 N·m
2.0 to 3.0 kgf·m
14.5 to 21.7 ft-lbs
98.1 to 147.1 N·m
10.0 to 15.0 kgf·m
72.3 to 108.5 ft-lbs
(2) Lock Nut
W1027783
W1027886
W1027950
KiSC issued 03, 2008 A