Servicing - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

(3) Servicing

(A) Air Conditioning Unit
Heater Hoses
1. Disconnect the heater hoses (1), (2), and take out them under the
cabin.
NOTE
• Connect the heater hose (1) to the heat hose which comes
from cabin with blue painted hose.
(1) Heater Hose 1
Inner Covers
1. Remove the inner covers (1) and (2).
(1) Inner Cover (Upper)
Removing Heater Hoses
1. Remove the outer roof.
2. Disconnect the heater hoses (1), (2).
3. Pull out the heater hoses (1), (2) from the bottom of the cabin.
4. Take out the heater hoses (1), (2).
(When reassembling)
• When connecting the heater hose with A/C unit, hose should be
put into the A/C unit pipe more than 30 mm (1.2 in.).
• Be sure to fix the heater hose (2) to the original position.
(1) Heater Hose 1
Evaporator
1. Check whether white powder or dust is attached to the
evaporator (1). If they are attached, wash them off with warm
water and blow them off with compressed air.
NOTE
• In case the evaporator is cleaned with warm water, cap the
evaporator pipe ends so that water does not enter it.
(1) Evaporator
10-S44
(2) Heater Hose 2
W1033326
(2) Inner Cover (Lower)
W1033483
(2) Heater Hose 2 with Blue Paint
W1033741
KiSC issued 03, 2008 A
CABIN