Disassembling Front Axle [2Wd Type] - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

(3) Disassembling Front Axle [2WD Type]

Front Axle
1. Place a disassembling stand under the front axle case and
support it with a jack.
2. Loosen the lock nut (1) and remove the spring (2).
3. Remove the bracket (front) mounting screws and nuts.
4. Remove the bracket (rear) mounting screws and nuts.
5. Separate the front axle from front axle bracket.
(When reassembling)
• Be sure to adjust the length of A and B.
Length Factory spec.
Bracket mounting nut
Tightening torque
Bracket mounting screw
IMPORTANT
• Be sure to adjust the front axle pivot.
(1) Lock Nut
(2) Spring
Front Wheel Hub
1. Remove the front wheel cap (1).
2. Draw out the cutter pin.
3. Remove the slotted nut (2).
4. Remove the collar.
5. Remove the front wheel hub (3) with puller.
(When reassembling)
• Replace cotter pin with a new one.
• Apply grease to the oil seal and bearing in the front wheel hub.
Tightening torque Front wheel hub slotted nut
IMPORTANT
• After tightening the slotted nut to the specified torque,
measure the front wheel hub turning torque.
• If the measurement is not within the factory specifications,
adjust with the slotted nut.
Front wheel hub turning
Factory spec.
torque
(1) Front Wheel Cap
(2) Slotted Nut
(3) Front Wheel Hub
6-S10
FRONT AXLE
A = B
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 ft-lbs
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 ft-lbs
(3) Differential Lock Lever
W1013843
29.4 to 39.2 N·m
3.0 to 4.0 kgf·m
21.7 to 28.9 ft-lbs
2.94 to 4.90 N·m
0.3 to 0.5 kgf·m
2.17 to 3.62 ft-lbs
(a) Grease
W1014230
KiSC issued 03, 2008 A