Handling Of Service Tools; Manifold Gauge Set - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM
(Reference)
Replacing Parts
Type 1 (swashplate Type)
40 cc
Condenser 0.042 U.S.qts.
0.036 Imp.qts.
40 cc
Evaporator 0.042 U.S.qts.
0.036 Imp.qts.
10 cc
Receiver 0.011 U.S.qts.
0.009 Imp.qts.
10 cc
Hose 0.011 U.S.qts.
0.009 Imp.qts.
*PAG : Polyalkyleneglycol (Synthetic oil)

[1] HANDLING OF SERVICE TOOLS

(1) Manifold Gauge Set

Replenish Quantity
Type 2 and 3
(Scroll Type Compressor)
20 cc
0.021 U.S.qts.
0.018 Imp.qts.
20 cc
0.021 U.S.qts.
0.018 Imp.qts.
10 cc
0.011 U.S.qts.
0.009 Imp.qts.
10 cc
0.011 U.S.qts.
0.009 Imp.qts.
The hand valves on the manifold gauge set are used to open and
close the valve. The hand valve inscribed LO is for the low pressure
side valve (3) and HI is for the high pressure side valve (4). By
opening or closing the high and low pressure hand valves, the
following circuits are established.
(1) LO Pressure Gauge
(2) HI Pressure Gauge
(3) LO Pressure Side Valve
When LO Pressure Side Valve and HI Pressure Side Valve
are Closed
Two circuits are established.
Port (C) → LO pressure gauge (1)
Port (A) → HI pressure gauge (2)
NOTE
• Schrader valve (D) must be opened.
When LO Valve is Opened and HI Valve is Closed
Two circuits are established.
Port (C) → LO pressure gauge (1)
→ Port (B)
→ Port (D)
Port (A) → HI pressure gauge (2)
NOTE
• Schrader valve (D) must be opened.
10-S9
Brand Name
DENSO CO.
ND-OIL 8
<PAG* oil>
(4) HI Pressure Side Valve
(5) Schrader Valve
CABIN
W1012709
W1013107
W1013376
W1013454
KiSC issued 03, 2008 A