Disassembling And Assembling - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

(2) Disassembling and Assembling

(A) Separating Engine from Clutch Housing Case
Draining Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plug (1).
3. Drain the transmission fluid.
4. Reinstall the drain plug (1).
(When reassembling)
• Fill up from filling port after removing the filling plug until reaching
the gauge.
• After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not correct
level.
Transmission fluid Capacity
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
• Refer to "5. LUBRICANTS,
GENERAL Section.
• Do not mix different brands fluid together.
(1) Drain Plug
Muffler and Bonnet
1. Remove the muffler (1).
2. Remove the bonnet (2).
3. Disconnect the battery's cable.
4. Disconnect the head light 3P connectors.
5. Remove the front lower cover (4) and side cover (5).
IMPORTANT
• When disconnecting the battery cords, disconnect the
grounding cord first. When connecting, positive cord first.
(1) Muffler (Upper)
(2) Bonnet
(3) Battery
2-S5
CLUTCH
43 L
M6800(S) 45.4 U.S.qts.
37.8 Imp.qts.
54 L
M8200
57.0 U.S.qts.
M9000
47.5 Imp.qts.
FUEL AND COOLANT" at
(4) Front Lower Cover
(5) Side Cover
KiSC issued 03, 2008 A
W1012568
W1013060