Kubota M6800S Workshop Manual page 227

M6800 · M6800S · M8200 · M9000, WSM
Disassembling Bearing Holder and 21T Gear Shaft
1. Remove the internal snap ring (9).
2. Tap out the 21T gear shaft with bearing.
(When reassembling)
• Take care of direction of the oil seal.
• Apply grease to the oil seal and bushing.
• Take care of the position of needle bearing and collars.
• Apply transmission fluid to the bearing.
• Put on the PTO propeller shaft guide to the PTO propeller shaft
to prevent the oil seal (7) damaging. (Refer to "9. SPECIAL
TOOLS" at GENERAL Section.)
(1) Bearing Holder
(2) 21T Gear Shaft
(3) Oil Seal
(4) Collar
(5) Needle Bearing
Shift Levers and Bearing Retainer
1. Remove the shift lever stopper (5).
2. Tap out the spring pin (1) from Hi-Creep shift lever (2).
3. Draw out the Hi-Creep shift lever (2).
4. Tap out the spring pin (6) from Low-Reverse shift lever (3).
5. Draw out the Low-Reverse shift lever (3).
6. Remove the bearing retainers (4).
(When reassembling)
• Apply grease to the O-ring.
(1) Spring Pin
(2) Shift Lever (H-C)
(3) Shift Lever (L-R)
3-S16
TRANSMISSION
(6) Bushing
(7) Oil Seal
(8) Collar
(9) Internal Snap Ring
W1018950
(4) Bearing Retainer
(5) Stopper
(6) Spring Pin
W1019202
KiSC issued 03, 2008 A