Kubota M6800S Workshop Manual page 312

M6800 · M6800S · M8200 · M9000, WSM
Draining Front Differential Case Oil
1. Place oil pan underneath the differential case.
2. Remove the drain plug (1) and filling plug (2) to drain the oil.
3. After draining, reinstall the drain plug (1) and filling plug (2).
M6800(S)
M8200
Oil capacity
M9000
(1) Drain Plug
(2) Filling Plug
Propeller Shaft
1. Slide the propeller shaft cover (3), (5) after removing the screws
(6).
2. Tap out the spring pin (2), (4) and then slide the coupling (1), (8)
to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
Front Wheel and Power Steering Hoses
1. Check the front axle and engine are securely mounted on the
disassembly stand.
2. Loosen the front wheel mounting nuts.
3. Lift the front axle and remove the front wheels.
4. Remove the cylinder cover (3).
5. Disconnect the power steering hoses (1), (2).
(When reassembling)
Power steering hose
retaining nut
Cylinder cover mounting
Tightening torque
screw
Front wheel mounting nut
(1) Power Steering Hose 1
(2) Power Steering Hose 2
6-S9
FRONT AXLE
5.0 L
5.3 U.S.qts.
4.4 Imp.qts.
6.0 L
6.3 U.S.qts.
5.3 Imp.qts.
(3) Oil Level Check Plug
W1013245
(5) Propeller Shaft Cover
(6) Screw
(7) Propeller Shaft
(8) Coupling
W1024467
24.5 to 29.4 N·m
2.5 to 3.0 kgf·m
18.1 to 21.7 ft-lbs
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 ft-lbs
(3) Cylinder Cover
W1013645
KiSC issued 03, 2008 A