Kubota M6800S Workshop Manual page 298

M6800 · M6800S · M8200 · M9000, WSM
1. STRUCTURE
The front axle supports the front of tractor and facilitates steering.
There are two kinds of front axles.
The two-wheel drive axle has free-running front wheels and four-wheel drive axle has powered front wheels.
[1] 2 WHEEL DRIVE TYPE
(1) Front Wheel Hub
(2) Slotted Nut
(3) Taper Roller Bearing
(4) Knuckle Arm
(5) Knuckle Shaft Bushing
(6) Knuckle Shaft Dowel Pin
The front axle of the 2WD type is constructed as shown above.
The knuckle shaft (7) is installed to the front axle (11) by the "RUMOAN" method.
With this method, the shape of the front axle is relatively simple, and front axle is supported at its center with the
front axle support (12) on the front axle bracket (13), so that steering operation is stable even on an uneven ground
encountered in a farm field.
(7) Knuckle Shaft
(8) Knuckle Dust Proof Cover
(9) Knuckle Stub Gasket
(10) Front Axle Middle
(11) Front Axle
(12) Front Axle Support
(13) Front Axle Bracket
(14) Power Steering Cylinder
(15) Power Steering Cylinder
Bracket
6-M1
FRONT AXLE
(16) Bracket (Front)
(17) Oil Seal
(18) Bushing
(19) Center Pin
(20) Bracket (Rear)
KiSC issued 03, 2008 A