Wheel Hub; Tire Pressure - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

[3] WHEEL HUB

[4] TIRE PRESSURE

CAUTION
• Do not attempt mount a tire. This should be done by a qualified person with the proper equipment.
IMPORTANT
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
• Excessive wear of tires may occur due to improper gear ratio.
Screw circle diameter 152.4 mm
(A)
Number of screws
M14 × P1.5
Screws
114.0 mm
Hub pilot diameter (B)
(4.488 in.)
Through the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it every day
and inflate as necessary.
To inflate the wheel tires, use an air compressor or hand pump.
Recommended Inflation Pressure
• Maintain the pressure shown below for normal use.
Tire sizes
7.50 – 16
7.50 – 18
Front 9.50 – 24
11.2 – 24
12.4 – 24
16.9 – 30
Rear 18.4 – 28
18.4 – 30
NOTE
• Maintain the maximum pressure in front tires, if using a front
loader of when equipped with lots of front weight.
(A) Insufficient
(B) Standard
G-58
Front wheel hub
2WD 4WD
203.2 mm
(6 in.) (8 in.)
6 8
M16 × P1.5
152.4 mm
(6 in.)
Inflation pressure
2
280 kPa (2.8 kgf/cm , 40 psi)
2
280 kPa (2.8 kgf/cm , 40 psi)
2
180 kPa (1.8 kgf/cm , 26 psi)
2
160 kPa (1.6 kgf/cm , 23 psi)
2
140 kPa (1.4 kgf/cm , 20 psi)
2
120 kPa (1.2 kgf/cm , 18 psi)
2
110 kPa (1.1 kgf/cm , 16 psi)
2
110 kPa (1.1 kgf/cm , 16 psi)
(C) Excessive
(D) Ground
G GENERAL
Rear wheel hub
–
203.2 mm
(8 in.)
8
M16 × P1.5
152.4 mm
(6 in.)
W1043392
W1027488
KiSC issued 03, 2008 A